Page 1 of 1

Strongs Number pop-up

Posted: Sun May 08, 2011 10:40 am
by novar
I'm running BA v4.0 When I hover over the strong's number in AVs tab the pop-up says Strong's Dictionary not loaded. Yet the strongs number and definition show up in the dictionary panel Strong's TVM Tab. Can you fix the pop-up issue? Or is there a setting or module I need to download to make the pop-up work correctly?
Thanks
Robert

PS Great Program!

Re: Strongs Number pop-up

Posted: Sun May 08, 2011 11:58 am
by Tim
You must have the newer StrongEX module. v4.0 won't recognize it since it is a new feature of 4.1. Try updating to v4.2 and see if the popup works, http://www.BibleAnalyzer.com/BA-Update421.exe.

Re: Strongs Number pop-up

Posted: Tue May 10, 2011 7:49 am
by novar
Tim, I downloaded 4.2 and ran the program and the po-up still shows strong's not loaded. Any ideas?
Thanks
Robert

Re: Strongs Number pop-up

Posted: Tue May 10, 2011 3:49 pm
by Tim
Look in you Modules/Dictionaries folder for a file named Stongs.dct. If there is one named strong.dct, rename it to strongs.dct.

Re: Strongs Number pop-up

Posted: Tue May 10, 2011 9:53 pm
by novar
I checked and there is only a s-strong and an s-strong.idx files.
Is there just a strongs file I can download to replace these so the po-up will work?
Robert

Re: Strongs Number pop-up

Posted: Tue May 10, 2011 10:28 pm
by Tim
Try this one,
http://www.bibleanalyzer.com/files/s-strongEx.zip

Just extract it to the dictionaries folder.

Re: Strongs Number pop-up

Posted: Fri May 13, 2011 12:59 am
by novar
Tim, I downloaded and extracted the s-strongs to the dictionary folder, but I still have the same issue. If I purched the new CD would the strongs pop up work then? I'd sure like to take advantage of thr new updated tools.
Thanks
Robert

Re: Strongs Number pop-up

Posted: Thu May 03, 2012 11:35 am
by srice
I come across this thread, because I too have been having this problem. I'm on a Mac, and I think on Linux this worked for me. I can look stuff up in the Strong's dictionary, however pop up doesn't work and the error message is:

Code: Select all

"Strong's Dictionary not loaded see Bibleanalyzer.com" 
Any ideas?

Shane

Re: Strongs Number pop-up

Posted: Thu May 03, 2012 3:22 pm
by Tim
An older module most likely,

Go to your
/Library/Application Support/Bible Analyzer/Modules/Dictionary
folder and look for any .dct files that have "strongs" in them. You only want s-strongsEx.dct. Remove the others. If you don't have it, download it here,
www.bibleanalyzer.com/files/s-strongsEx.zip
and extract it in that folder.

If you still have trouble, let me know.

Re: Strongs Number pop-up

Posted: Thu May 03, 2012 4:28 pm
by srice
That did it! Thanks! I moved a bunch of files around and cleaned up an old installation while I had my sleeves rolled up. At any rate that did fix the problem.

Shane